Designed and open-sourced by Th0mpy, the Voron V0.2 RP2040 1.3″ Display it’s a low cost display with a USB-C connection.
The RP2040 microcontroller used in this display more powerful and versatile when compared to the ST microcontroller used in the original Voron0 display.
The display includes both a USB-C and pin header to connect back the main controller. Please note, only one may be used at a time.
Our display has the RGB Led included that can be configured to light up different colors according to different actions and status. Encoder rotates and clicks to allow navigation through the menu. Reset button on the right.
Recommend for Voron v0.2 with any motherboard and fits original printed parts.
- This item is fully soldered and in ready condition to be used.
- Includes a black color USB-C 90 degrees cable with 30cm.
- Pre-flashed with klipper. Just Plug and play.
Klipper config:
[mcu v02display] #serial: /dev/serial/by-id/[modify this value] to match your board, by running ls /dev/serial/by-id/* Check the example below serial: /dev/serial/by-id/usb-Klipper_rp2040_E6625495537C5221-if00 restart_method: command [display] lcd_type: sh1106 i2c_mcu: v02display i2c_bus: i2c0a vcomh: 31 x_offset: 2 encoder_pins: ^v02display:gpio7, ^v02display:gpio6 click_pin: ^!v02display:gpio8 kill_pin: ^!v02display:gpio5 [neopixel v02display] pin: v02display:gpio16 chain_count: 1 color_order: GRB initial_RED: 1 initial_GREEN: 0 initial_BLUE: 0
Author and info: https://github.com/VoronDesign/Voron-Hardware/tree/master/V0_Display_RP2040
For USA visitors, please buy it here https://www.etsy.com/listing/1458617388/voron0-13-display-based-on-the-rp2040
Not sure what display you need to buy?
| Printer has the SKR MINI E3 V1.2 or V2 or V3 or any other board with a single EXP 10 ribbon cable connector | Printer has an SKR PICO or any other board with NO EXP 10 ribbon cable connector | Printer has a OCTOPUS or MANTA Board or any other board with 2x EXP 10 ribbon cable connector | |
| Can I use a 12864 display? | Yes. You can use a 12864 RGB display with the SKR Adpator for v1.2 / v2 or v3. | No | Yes. You can use a 12864 RGB display directly and don’t need anything else. |
| Is there a display that works directy with this board with no hassle? | Yes. The Hartk Simple display | Yes. Our new V0.2 RP2040 Display can be connect to the RPI by a USB-C cable or header cable. | Yes. You can use a 12864 RGB display directly and don’t need anything else. |
